To mount the faceplate, follow these steps:
- Unscrew the holding screw from the bottom of the siren with a PH2 screwdriver if the siren is mounted on SmartBracket mounting panel.
- Remove the siren from SmartBracket mounting panel. To do this, lightly press the panel and slide it down.
- Place the front side of the siren on a hard surface and unscrew the 4 screws on the rear panel with a PH2 screwdriver.
- Turn the siren over, holding the front and back of its enclosure. Remove the protective plastic panel.
When installing the panel, do not remove the plastic frame or detach the LED strip from the seat.
- Drill a hole in the protective plastic panel at the defined location.
There might be a non-hardening sealant on the piezoelectric detector and in the hole of the protective plastic panel. Do not remove it! If the sealant gets on your hands, clean them with a napkin.
- Mount Brandplate on the protective plastic panel.
- Fix the Brandplate to the protective plastic panel using the bundled bolt.
- Install the protective plastic panel in place with a little effort. Ensure that the Ajax logo aligns with the connection side of the LED strip to the board. Once correctly installed, the plastic panel should protrude no more than 1.0 to 1.5 mm above the LED frame.
- Turn the siren over, holding the front and back of its enclosure, and tighten 4 screws.
- Slide the device onto the SmartBracket mounting panel.
